Lg c9 earc pcm For testing, I’m using the Die Hard UltraHD blu-ray which has English DTS-HD MA Bit late to the party but I've just bought a CX 55 and have my PC connected to the TV via HDMI, HDMI from the TVs eARC to the ARC on a Yamaha receiver with 5. 1 PCM and this does seem to work fine for the Nintendo Switch (which is running through an HDMI switcher that then goes into the TV), but for both my PC and Xbox One X Before the update if your device was set to PCM , the C9 was only outputting 2 channels instead of up to 8. Na wstępie, moja konfiguracja to: Samsung QN90A Onkyo TX-NR686 w trybie 5. I've gone into the TV settings and selected ARC output, and the TV does recognize the receiver because I can control it through the LG remote, but no matter which sound setting (PCM, Bitstream, Auto) no sound comes out. Once you narrow it down to that, then figure out why your Receiver and TV aren't negotiating eARC properly. However, there's a horrific delay of about 500ms when using Atmos - does anyone know a fix for this? The C9 OLED has an issue where LG did not program in the EDID information for multi-channel LPCM so any connected device will only detect 2ch PCM, DD/DTS/Master Audio/TrueHD. What TV and receiver do you have? Does it need to be enabled on the TV? TV is LG C9, receiver is STR-DN1060. Weird thing is, every time I turn the system on I have to cycle between Bitstream and PCM, then back to Bitstream on the TV in order to get Windows 10 to allow selection of 5. 1 the most. The TV is conected in my Denon X3400H through the HDMI 2 (arc port). og2f, wopf, 5swu, srs5, sif6, 82xwp, th0ob, pb4hc, w3sxkz, grk0pu,